Lock iconRectangle 1Rectangle 2 + Rectangle 2 CopyShapeRectangle 1
Free Shipping on all products!
Caring for your customers’ lacquered or varnished wood floor

Wood Floor -

Caring for your customers’ lacquered or varnished wood floor

How to care for your customers’ lacquered or varnished wood floor?

In Brief:

Equipment needed:

A clean mop

2 Compartment mop bucket

Pullmann wood floor cleaner

Pullmann Finish Care Stop

Commercial wood lacquer kit - this has everything you need to clean a wood floor

The process:

• If the floor is badly worn, sanding might be required

• Clean the floor completely with a vacuum cleaner

• Then using a two compartment bucket clean the floor

• Leave the floor to dry completely.

• Apply Pullmann Finish Care Stop, Do NOT this product on an oiled wood floor. Instead refer to our article Caring for your oiled wood floor.

• Leave to Dry for 30-40 mins

First of all make sure the floor is completely clean, for this you will need a clean mop and a two compartment bucket, then add a mild detergent cleaner such as Pallmann Neutral Cleaner. Start by sweeping or vacuuming the floor (use the soft brush head on the vacuum to avoid scratching the surface). A good option for this would be the SEBO Felix Pet, as it comes with a hard floor attachment.

Mix the cleaner into one section of your bucket, and then clean water in the other side, each side you clean the floor rinse with the clean water, mopping in a figure 8, approx 1 x 3 metres wide.

Once the wood floor has been completely cleaned you will then need to leave it until it has dried completely. Then apply the Pullmann Finish Care Stop, using a flat mop or T Bar applicator to achieve a very thin film over the floor.

Leave the floor for 30-40 mins and by this stage the its luster would have returned.